Last time we discovered that the FLSun QQ-S profile that comes with Cura 4.3.0 works pretty well, out-of-the-box. Of course there is always room for fine tuning.
Unfortunately, I did not make much progress this week, so today, I’m just going to share some of the more helpful links I’ve run across so you can progress on your own.
Introduction to Cura
All3dp has a good introduction to Cura. It’s not an all inclusive tutorial, however, it does include some nice explanations that can help demystify the process and some of the settings.
https://all3dp.com/1/cura-tutorial-software-slicer-cura-3d/
Trouble Shooting Guides
3dPrintingForBeginners has a nice page with a number of links for troubleshooting and more.
http://3dprintingforbeginners.com/troubleshoot-3d-printing-problems/
Owners Group
If you’re still at a loss, there is the FLSun QQ, QQ-S, and Q5 owners group on Facebook, some of which can be accessed without a facebook account.
https://www.facebook.com/groups/120961628750040/
I’ll pick this series back up when I have something to report.